4.11 ld and SPU ELF Support

--plugin

This option marks an executable as a PIC plugin module.

--no-overlays

Normally, ld recognizes calls to functions within overlay regions, and redirects such calls to an overlay manager via a stub. ld also provides a built-in overlay manager. This option turns off all this special overlay handling.

--emit-stub-syms

This option causes ld to label overlay stubs with a local symbol that encodes the stub type and destination.

--extra-overlay-stubs

This option causes ld to add overlay call stubs on all function calls out of overlay regions. Normally stubs are not added on calls to non-overlay regions.

--local-store=lo:hi

ld usually checks that a final executable for SPU fits in the address range 0 to 256k. This option may be used to change the range. Disable the check entirely with --local-store=0:0.

--stack-analysis

SPU local store space is limited. Over-allocation of stack space unnecessarily limits space available for code and data, while under-allocation results in runtime failures. If given this option, ld will provide an estimate of maximum stack usage. ld does this by examining symbols in code sections to determine the extents of functions, and looking at function prologues for stack adjusting instructions. A call-graph is created by looking for relocations on branch instructions. The graph is then searched for the maximum stack usage path. Note that this analysis does not find calls made via function pointers, and does not handle recursion and other cycles in the call graph. Stack usage may be under-estimated if your code makes such calls. Also, stack usage for dynamic allocation, e.g. alloca, will not be detected. If a link map is requested, detailed information about each function's stack usage and calls will be given.

--emit-stack-syms

This option, if given along with --stack-analysis will result in ld emitting stack sizing symbols for each function. These take the form __stack_<function_name> for global functions, and __stack_<number>_<function_name> for static functions. <number> is the section id in hex. The value of such symbols is the stack requirement for the corresponding function. The symbol size will be zero, type STT_NOTYPE, binding STB_LOCAL, and section SHN_ABS.