Many linker scripts are fairly simple.
The simplest possible linker script has just one command: SECTIONS. You use the SECTIONS command to describe the memory layout of the output file.
The SECTIONS command is a powerful command. Here we will describe a simple use of it. Let's assume your program consists only of code, initialized data, and uninitialized data. These will be in the .text, .data, and .bss sections, respectively. Let's assume further that these are the only sections which appear in your input files.
For this example, let's say that the code should be loaded at address 0x10000, and that the data should start at address 0x8000000. Here is a linker script which will do that:
SECTIONS
{
. = 0x10000;
.text : { *(.text) }
. = 0x8000000;
.data : { *(.data) }
.bss : { *(.bss) }
}
You write the SECTIONS command as the keyword SECTIONS, followed by a series of symbol assignments and output section descriptions enclosed in curly braces.
The first line inside the SECTIONS command of the above example sets the value of the special symbol ., which is the location counter. If you do not specify the address of an output section in some other way (other ways are described later), the address is set from the current value of the location counter. The location counter is then incremented by the size of the output section. At the start of the SECTIONS command, the location counter has the value 0.
The second line defines an output section, .text. The colon is required syntax which may be ignored for now. Within the curly braces after the output section name, you list the names of the input sections which should be placed into this output section. The * is a wildcard which matches any file name. The expression *(.text) means all .text input sections in all input files.
Since the location counter is 0x10000 when the output section .text is defined, the linker will set the address of the .text section in the output file to be 0x10000.
The remaining lines define the .data and .bss sections in the output file. The linker will place the .data output section at address 0x8000000. After the linker places the .data output section, the value of the location counter will be 0x8000000 plus the size of the .data output section. The effect is that the linker will place the .bss output section immediately after the .data output section in memory.
The linker will ensure that each output section has the required alignment, by increasing the location counter if necessary. In this example, the specified addresses for the .text and .data sections will probably satisfy any alignment constraints, but the linker may have to create a small gap between the .data and .bss sections.
That's it! That's a simple and complete linker script.