You cannot select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
65 lines
1.5 KiB
Plaintext
65 lines
1.5 KiB
Plaintext
/*
|
|
SD card file dump
|
|
|
|
This example shows how to read a file from the SD card using the
|
|
SD library and send it over the serial port.
|
|
|
|
The circuit:
|
|
* SD card attached to SPI bus as follows:
|
|
** MOSI - pin 11
|
|
** MISO - pin 12
|
|
** CLK - pin 13
|
|
** CS - pin 4
|
|
|
|
created 22 December 2010
|
|
|
|
This example code is in the public domain.
|
|
|
|
*/
|
|
|
|
#include <SD.h>
|
|
|
|
// On the Ethernet Shield, CS is pin 4. Note that even if it's not
|
|
// used as the CS pin, the hardware CS pin (10 on most Arduino boards,
|
|
// 53 on the Mega) must be left as an output or the SD library
|
|
// functions will not work.
|
|
const int chipSelect = 4;
|
|
|
|
void setup()
|
|
{
|
|
Serial.begin(9600);
|
|
Serial.print("Initializing SD card...");
|
|
// make sure that the default chip select pin is set to
|
|
// output, even if you don't use it:
|
|
pinMode(10, OUTPUT);
|
|
|
|
// see if the card is present and can be initialized:
|
|
if (!SD.begin(chipSelect)) {
|
|
Serial.println("Card failed, or not present");
|
|
// don't do anything more:
|
|
return;
|
|
}
|
|
Serial.println("card initialized.");
|
|
|
|
// open the file. note that only one file can be open at a time,
|
|
// so you have to close this one before opening another.
|
|
File dataFile = SD.open("datalog.txt");
|
|
|
|
// if the file is available, write to it:
|
|
if (dataFile) {
|
|
while (dataFile.available()) {
|
|
Serial.write(dataFile.read());
|
|
}
|
|
dataFile.close();
|
|
}
|
|
// if the file isn't open, pop up an error:
|
|
else {
|
|
Serial.println("error opening datalog.txt");
|
|
}
|
|
}
|
|
|
|
void loop()
|
|
{
|
|
}
|
|
|