hetzner-dracut-sshd/README.md

hetzner-dracut-sshd

🚧 Work in progress 🚧

Post-install script for Hetzner's installimage that installs dracut-sshd to enable remote LUKS unlocking via SSH.

This is tested with Rocky Linux 10. It should also work with AlmaLinux 10 and possibly earlier releases, but these have not been tested.

Notes

• The script assumes a setup with LVM on LUKS on RAID1, but this is not a strict requirement. Other setups may require small changes to the script.
• Configures the initramfs to enable networking (e.g. NetworkManager) in early boot
  • dracut-network, NetworkManager in the initramfs and rd.neednet=1 in the kernel cmdline
  • Reuses the static IP configuration that installimage configures (via dracut-network)
• Enables EPEL (required for dracut-sshd)
• Installs dracut-sshd
  • Uses the SSH keys in /root/.ssh/authorized_keys, as previously installed by installimage
• Always check /root/postinstall_debug.txt after installimage ran.

After rebooting out of the rescue system

• The system reboots again after first boot due to SELinux autorelabeling. That means that you will need to ssh into the initrd to unlock twice if it's the first time.

Troubleshooting

• Always check /root/postinstall_debug.txt after postinstall ran.
• It's not specific to this postinstall script, but make sure you know how to mount an encrypted system from the rescue disk using mdadm, cryptsetup, lvscan etc. Also remember to touch /path-to/mounted-system/.autorelabel` after tinkering, to not break booting due to SELinux choking on unlabeled files.